|
The RHEL ClusterSuite included with RHEL2.1 and 3 is using lvs，it's easy to
use，u even don't need recompile the kernel in RHEL
u may edit the lvs.cf under /etc/sysconfig/ha/，and start the pulse service
i have been using it for about 3 years，（DR under RHEL2.1 3years，TUNE under RHEL
3 about 2years），it is very stable，in real server，i am using noarp module too。
-----原始邮件-----
发件人: Ryan Leathers [mailto:Ryan.Leathers@xxxxxxxxxxxxxxxxxxx]
发送时间: 2004年10月13日 20:02
收件人: 'LinuxVirtualServer.org users mailing list.'
主题: RE: LVS on RHEL + Piranha
I used to use Piranha on RHEL 2.1 for LVS-NAT, but when I needed DR it was
too troublesome. I eventually started using Ultra Monkey instead.
-----Original Message-----
From: Mohd Irwan b. Jamaluddin [mailto:irwan@xxxxxxxxxxxx]
Sent: Tuesday, October 12, 2004 10:52 PM
To: lvs-users@xxxxxxxxxxxxxxxxxxxxxx
Subject: LVS on RHEL + Piranha
Good day,
I need to setup a geographical-based load balancing clustering solution.
My technical director would like to use Red Hat Enterprise Linux (RHEL) +
Piranha.
>From my understanding, RHEL only support/use NAT forwarding method - see
https://www.redhat.com/docs/manuals/enterprise/RHEL-3-Manual/cluster-suite/s
1-lvs-routing.html
Does anybody successfully deploy RHEL + Piranha but using other forwarding
method (Tunnelling or Direct Routing)?
--
Regards,
Mohd Irwan b. Jamaluddin
System Engineer,
Magnifix Sdn. Bhd. [http://www.magnifix.com/]
Tel: 603-4270 5073 (Office)
Tel: 6019-2161 793 (Mobile)
_______________________________________________
LinuxVirtualServer.org mailing list - lvs-users@xxxxxxxxxxxxxxxxxxxxxx
Send requests to lvs-users-request@xxxxxxxxxxxxxxxxxxxxxx
or go to http://www.in-addr.de/mailman/listinfo/lvs-users
_______________________________________________
LinuxVirtualServer.org mailing list - lvs-users@xxxxxxxxxxxxxxxxxxxxxx
Send requests to lvs-users-request@xxxxxxxxxxxxxxxxxxxxxx
or go to http://www.in-addr.de/mailman/listinfo/lvs-users
|
