|
Hi Julian,
> I have an old document for tunnel troubleshooting. I just added
> > some configuration examples including recently supported tunnel modes,
> HTH:
> >
> > http://ja.ssi.bg/TUN-HOWTO.txt <http://ja.ssi.bg/TUN-HOWTO.txt>
> >
> > At the moment with LVS, VIP on the real-server is not set to the loopback
> > interface but the tunl0 interface.
> >
> > It works, as long as tunl0/hidden is set to 1, if this flag is
> > used to stop ARP replies. Otherwise, the recommended device for VIPs
> > is lo.
> >
>
Thanks a lot for sharing that how-to document. It was pretty clear and
concise.
I followed the document to setup LVS once again from scratch, but
unfortunately it didn't resolve the response issue :(
This time I tried binding the VIP on 'lo' interface instead of 'tunl0' on
the real-server, and still bring tunl0 up as in your doc, but no luck.
All the troubleshooting steps in your doc, like 'ip route get...' resolve
fine.
I don't see any IPIP packet decoding happening on the real-server when I do
a tcpdump. Here's how it looks:
tunl0: CIP -> VIP (packet length 40; checksum correct)
ens3: VIP -> CIP (packet length 0; checksum correct)
This goes on for 4-5 times until timeout on the client.
Anyway, please share if anything else comes to your mind.
Have a good day.
Cheers,
Nick
_______________________________________________
Please read the documentation before posting - it's available at:
http://www.linuxvirtualserver.org/
LinuxVirtualServer.org mailing list - lvs-users@xxxxxxxxxxxxxxxxxxxxxx
Send requests to lvs-users-request@xxxxxxxxxxxxxxxxxxxxxx
or go to http://lists.graemef.net/mailman/listinfo/lvs-users
|
