|
Fix misspellings of "disconnect", "disconnecting", "connections", and
"disconnected".
Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
---
drivers/net/wimax/i2400m/usb.c | 2 +-
drivers/net/wireless/realtek/rtlwifi/rtl8192se/hw.c | 4 ++--
include/net/cfg80211.h | 2 +-
net/netfilter/ipvs/ip_vs_ovf.c | 2 +-
net/wireless/reg.h | 2 +-
5 files changed, 6 insertions(+), 6 deletions(-)
diff --git a/drivers/net/wimax/i2400m/usb.c b/drivers/net/wimax/i2400m/usb.c
index 6953f904232f8d9b..9659f9e1aaa64c8a 100644
--- a/drivers/net/wimax/i2400m/usb.c
+++ b/drivers/net/wimax/i2400m/usb.c
@@ -511,7 +511,7 @@ int i2400mu_probe(struct usb_interface *iface,
/*
- * Disconect a i2400m from the system.
+ * Disconnect a i2400m from the system.
*
* i2400m_stop() has been called before, so al the rx and tx contexts
* have been taken down already. Make sure the queue is stopped,
diff --git a/drivers/net/wireless/realtek/rtlwifi/rtl8192se/hw.c
b/drivers/net/wireless/realtek/rtlwifi/rtl8192se/hw.c
index 6d6e8994460d90ba..81313e0ca83411f7 100644
--- a/drivers/net/wireless/realtek/rtlwifi/rtl8192se/hw.c
+++ b/drivers/net/wireless/realtek/rtlwifi/rtl8192se/hw.c
@@ -1352,9 +1352,9 @@ static void _rtl92s_phy_set_rfhalt(struct ieee80211_hw
*hw)
/* SW/HW radio off or halt adapter!! For example S3/S4 */
} else {
/* LED function disable. Power range is about 8mA now. */
- /* if write 0xF1 disconnet_pci power
+ /* if write 0xF1 disconnect_pci power
* ifconfig wlan0 down power are both high 35:70 */
- /* if write oxF9 disconnet_pci power
+ /* if write oxF9 disconnect_pci power
* ifconfig wlan0 down power are both low 12:45*/
rtl_write_byte(rtlpriv, 0x03, 0xF9);
}
diff --git a/include/net/cfg80211.h b/include/net/cfg80211.h
index 4ab2c49423dcba4b..ab6850bbba995e15 100644
--- a/include/net/cfg80211.h
+++ b/include/net/cfg80211.h
@@ -6593,7 +6593,7 @@ struct cfg80211_roam_info {
* time it is accessed in __cfg80211_roamed() due to delay in scheduling
* rdev->event_work. In case of any failures, the reference is released
* either in cfg80211_roamed() or in __cfg80211_romed(), Otherwise, it will be
- * released while diconneting from the current bss.
+ * released while disconnecting from the current bss.
*/
void cfg80211_roamed(struct net_device *dev, struct cfg80211_roam_info *info,
gfp_t gfp);
diff --git a/net/netfilter/ipvs/ip_vs_ovf.c b/net/netfilter/ipvs/ip_vs_ovf.c
index 78b074cd54646923..c03066fdd5ca69a3 100644
--- a/net/netfilter/ipvs/ip_vs_ovf.c
+++ b/net/netfilter/ipvs/ip_vs_ovf.c
@@ -5,7 +5,7 @@
* Authors: Raducu Deaconu <rhadoo_io@xxxxxxxxx>
*
* Scheduler implements "overflow" loadbalancing according to number of active
- * connections , will keep all conections to the node with the highest weight
+ * connections , will keep all connections to the node with the highest weight
* and overflow to the next node if the number of connections exceeds the
node's
* weight.
* Note that this scheduler might not be suitable for UDP because it only uses
diff --git a/net/wireless/reg.h b/net/wireless/reg.h
index dc8f689bd46902af..f9e83031a40a5eb3 100644
--- a/net/wireless/reg.h
+++ b/net/wireless/reg.h
@@ -114,7 +114,7 @@ void regulatory_hint_country_ie(struct wiphy *wiphy,
u8 country_ie_len);
/**
- * regulatory_hint_disconnect - informs all devices have been disconneted
+ * regulatory_hint_disconnect - informs all devices have been disconnected
*
* Regulotory rules can be enhanced further upon scanning and upon
* connection to an AP. These rules become stale if we disconnect
--
2.17.1
|
