Tim Wolfe wrote:
>
> I think I've got this setup correctly, but when I try to view the webpage, I
> never see an active www connection
> on either of the Real Servers, even though the ippfvsadm shows connections
> being made. Any hints on what I'm doing
> wrong?
>
> Thanks,
>
> Tim
>
> This is my config:
>
> Load Director:
>
> ippfvsadm -L
> IP Port Forwarding & Virtual Server Table (Version 0.7)
> Protocol Local Addr:Port ==>
> Remote Addr:Port Weight Connections
> ...
> TCP 207.109.253.47:80 ==>
> 207.109.253.13:80 2 1
> 207.109.253.1:80 1 1
Are you trying to use Virtual Server via IP tunneling?
I see the output of 'ippfvsadm -L' that prints 'Remote Addr:Port',
because the remote port must be equal to the local port and the
remote port won't be printed out in virtual server via IP tunneling.
I guess you haven't enabled ippfvs using IP tunneling while building
kernel. Please try to enable the following option,
[ ] IP: enabling ippfvs using IP tunneling
and rebuild the kernel, finally see what happens.
By the way, the rest of your configuration is right.
Good luck,
Wensong
> $ ifconfig
> lo Link encap:Local Loopback
> inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
> UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
> RX packets:634 errors:0 dropped:0 overruns:0
> TX packets:634 errors:0 dropped:0 overruns:0
>
> eth0 Link encap:10Mbps Ethernet HWaddr 00:20:18:2D:BA:EC
> inet addr:207.109.253.251 Bcast:207.109.253.255 Mask:255.255.255.0
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:23991 errors:0 dropped:0 overruns:0
> TX packets:3310 errors:0 dropped:0 overruns:0
> Interrupt:11 Base address:0x6100
>
> eth0:0 Link encap:10Mbps Ethernet HWaddr 00:20:18:2D:BA:EC
> inet addr:207.109.253.47 Bcast:207.109.253.255 Mask:255.255.255.0
> UP RUNNING MTU:1500 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0
> TX packets:0 errors:0 dropped:0 overruns:0
>
> Real Server #1:
>
> ifconfig
> lo Link encap:Local Loopback
> inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
> UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
> RX packets:205 errors:0 dropped:0 overruns:0 frame:0
> TX packets:205 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0
>
> tunl0 Link encap:IPIP Tunnel HWaddr
> inet addr:207.109.253.47 Mask:255.255.255.0
> UP RUNNING NOARP MTU:1480 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0
>
> eth0 Link encap:Ethernet HWaddr 00:40:05:58:0A:90
> inet addr:207.109.253.13 Bcast:207.109.253.255 Mask:255.255.255.0
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:579177 errors:0 dropped:0 overruns:0 frame:0
> TX packets:531418 errors:0 dropped:0 overruns:0 carrier:0
> collisions:4
> Interrupt:3 Base address:0x300
>
> eth0:0 Link encap:Ethernet HWaddr 00:40:05:58:0A:90
> inet addr:207.109.246.26 Bcast:207.109.246.255 Mask:255.255.255.0
> UP BROADCAST RUNNING MTU:1500 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0
>
> netstat -o
> Active Internet connections (w/o servers)
> Proto Recv-Q Send-Q Local Address Foreign Address State
> Timer
> tcp 0 0 webcluster.clipper.n:22 firewall.clipper.n:1022
> ESTABLISHED on (899.99/0)
> udp 0 0 webcluster.clipp:domain *:* off
> (0.00/0) 0
> udp 0 0 erpc.clipper.net:domain *:* off
> (0.00/0) 0
> udp 0 0 webcluster.clipp:domain *:* off
> (0.00/0) 0
> udp 0 0 localhost:domain *:* off
> (0.00/0) 0
> Active UNIX domain sockets (w/o servers)
> Proto RefCnt Flags Type State I-Node Path
> unix 2 [ ] STREAM 583501 /dev/log
> unix 2 [ ] STREAM CONNECTED 583500
> unix 2 [ ] STREAM 1321 /dev/log
> unix 2 [ ] STREAM CONNECTED 1320
> unix 2 [ ] STREAM 1245 /dev/log
> unix 2 [ ] STREAM CONNECTED 1244
> unix 2 [ ] STREAM 1178 /dev/log
> unix 2 [ ] STREAM CONNECTED 1177
> unix 2 [ ] STREAM 1099 /dev/log
> unix 2 [ ] STREAM CONNECTED 1098
> unix 2 [ ] STREAM 1010 /dev/log
> unix 2 [ ] STREAM CONNECTED 1009
> unix 2 [ ] STREAM 727 /dev/log
> unix 2 [ ] STREAM CONNECTED 726
>
> Real Server #2:
>
> ifconfig
> lo Link encap:Local Loopback
> inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
> UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
> RX packets:432 errors:0 dropped:0 overruns:0
> TX packets:432 errors:0 dropped:0 overruns:0
>
> tunl0 Link encap:UNSPEC HWaddr
> 00-00-00-00-00-00-00-F6-00-00-00-00-00-00-00-00
> inet addr:207.109.253.47 Bcast:207.109.253.255 Mask:255.255.255.0
> UP RUNNING NOARP MTU:1480 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0
> TX packets:0 errors:0 dropped:0 overruns:0
>
> eth0 Link encap:10Mbps Ethernet HWaddr 00:20:18:2C:9D:F8
> inet addr:207.109.253.1 Bcast:207.109.253.255 Mask:255.255.255.0
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:21068 errors:0 dropped:0 overruns:0
> TX packets:16937 errors:0 dropped:0 overruns:0
> Interrupt:10 Base address:0x6600
>
> eth0:0 Link encap:10Mbps Ethernet HWaddr 00:20:18:2C:9D:F8
> inet addr:207.48.103.1 Bcast:207.48.103.255 Mask:255.255.255.0
> UP BROADCAST RUNNING MTU:1500 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0
> TX packets:0 errors:0 dropped:0 overruns:0
>
> netstat -o
> Active Internet connections
> Proto Recv-Q Send-Q Local Address Foreign Address (State)
> User
> tcp 0 0 chinook.clipper.net:22 firewall.clipper.:1015 ESTABLISHED
> root on (899.99/0)
> udp 0 0 localhost:domain *:*
> off (0.00/0)
> 0
> udp 0 0 chinook.clipper:domain *:*
> off (0.00/0)
> 0
> udp 0 0 alphashop.com:domain *:*
> off (0.00/0)
> 0
> Active UNIX domain sockets
> Proto RefCnt Flags Type State Path
> unix 2 [ ] SOCK_STREAM UNCONNECTED 1236
> unix 2 [ ] SOCK_STREAM CONNECTED 1265
> unix 2 [ ] SOCK_STREAM UNCONNECTED 1266
> unix 2 [ ] SOCK_STREAM CONNECTED 2413
> unix 2 [ ] SOCK_STREAM UNCONNECTED 2414
>
> ----------------------------------------------------
> Timothy M. Wolfe | Why surf when you can Sail?
> tim@xxxxxxxxxxx | Join Oregon's Premier
> Sr. Network Engineer | Wireless Internet Provider!
> ClipperNet Corporation | http://www.clipper.net/
> ----------------------------------------------------
>
|