lvs-users
|
|
lvs-users
|
| To: | thomas.hoelsken@xxxxxx |
|---|---|
| Subject: | Re: How to setup the aliases (e.g. eth1:1 or eth0:1) |
| Cc: | lvs-users@xxxxxxxxxxxxxxxxxxxxxx |
| From: | Joseph Mack <mack.joseph@xxxxxxx> |
| Date: | Wed, 18 Oct 2000 07:56:54 -0400 |
thomas.hoelsken@xxxxxx wrote: > How I have to setup the alias devices for NAT and VS? turn on ip aliasing in the Networking section of the kernel configure. recompile the kernel and reboot with the new kernel Then you can use ifconfig to setup your aliased devices. $ifconfig eth0:1 ...... Joe -- Joseph Mack PhD, Senior Systems Engineer, Lockheed Martin contractor to the National Environmental Supercomputer Center, mailto:mack.joseph@xxxxxxx ph# 919-541-0007, RTP, NC, USA |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | How to setup the aliases (e.g. eth1:1 or eth0:1), thomas . hoelsken |
|---|---|
| Next by Date: | Many thanks for help! One last question ;-), thomas . hoelsken |
| Previous by Thread: | How to setup the aliases (e.g. eth1:1 or eth0:1), thomas . hoelsken |
| Next by Thread: | Re: How to setup the aliases (e.g. eth1:1 or eth0:1), Horms |
| Indexes: | [Date] [Thread] [Top] [All Lists] |