|
Alois Treindl wrote:
> Initially, I used Joe Mack's configure script. It got me a working
> LVS system quickly.
>
> I have now dropped that and use a simpler shell script to do the same
> configuration, learning what commands I needed out of the configuration
> created by Joe's configure script.
>
> (It should have a mode whereit just prints our its commands, instead
> of writing the rather wild rc- command file, or the rc-file should
> have such a mode to list its commands).
Once your director is working you can save the ipvsadm commands with
$ipvsadm-sav >ipvsadm.dump
and reload them later
$ipvsadm-restore <ipvsadm.dump
The rc.lvs file produced by the configure-lvs script does a lot of
network and other checking to make sure that the LVS will run.
It doesn't know whether it's running on the director or a real-server
till run time and I don't see any obvious way of outputting the commands
for each node.
Joe
--
Joseph Mack PhD, Senior Systems Engineer, Lockheed Martin
contractor to the National Environmental Supercomputer Center,
mailto:mack.joseph@xxxxxxx ph# 919-541-0007, RTP, NC, USA
|
