|
turn off portfast
On Thu, 2004-05-06 at 15:21, Sean Roe wrote:
> Hi All,
>
> I was looking for some info on cisco catalyst switches to help speed up
> the failover between my two director boxes. I have the following setup:
>
>
> |--------|-----|WebServer1|
> -- |LVS01 |--|Cisco |-----|WebServer2|
> | | |-----|WebServer3|
> ------| |Catalyst|-----|WebServer4|
> | | |-----|WebServer5|
> -- |LVS02 |--|Switch |-----|WebServer6|
> |--------|
> Virt LVS Real
> IP Servers Servers
>
> My Problem is that if lvs01 fails lvs takes over the load but it takes
> forever for the real servers to startusing the new one (5-6 minutes).
> It also seems that it works faster if I actually restart the httpd on
> each webserver. This is a LVS-NAT with multiple vertual IPS going to
> different ports on the webservers.
>
> Any suggestions?
>
> Sean
>
> _______________________________________________
> LinuxVirtualServer.org mailing list - lvs-users@xxxxxxxxxxxxxxxxxxxxxx
> Send requests to lvs-users-request@xxxxxxxxxxxxxxxxxxxxxx
> or go to http://www.in-addr.de/mailman/listinfo/lvs-users
--
Ryan Leathers <ryan.leathers@xxxxxxxxxxxxxxxxxxx>
Global Knowledge
|
