|
I sent this to the keepalived list, but haven't had a response. Has
anyone had a similar problem with keepalived?
I've run into a problem trying to add new VIPs and I just can't see what I'm
doing wrong.
The behavior essentially is that the keepalived process seems to get
stuck in a loop with the following messages rapidly repeating in my
log files with the new configuration in place:
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Using LinkWatch kernel
netlink reflector...
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Netlink reflector reports
IP 10.0.0.105 added
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Netlink reflector reports
IP 192.168.1.6 added
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Netlink reflector reports
IP 192.168.1.1 added
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Registering Kernel netlink reflector
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Registering Kernel netlink
command channel
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Registering gratutious ARP
shared channel
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Using LinkWatch kernel
netlink reflector...
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Netlink reflector reports
IP 10.0.0.105 added
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Netlink reflector reports
IP 192.168.1.6 added
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Netlink reflector reports
IP 192.168.1.1 added
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Registering Kernel netlink reflector
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Registering Kernel netlink
command channel
Feb 24 10:00:53 sea-gw-lb1 Keepalived_vrrp: Registering gratutious ARP
shared channel
While these messages are being printed, the VIP addresses are taken
down. Specifically, "ip addr list" shows that none of the VIPs are
configured on my external interface any longer.
I can't find anything wrong with my new configuration. I'm adding
four new VIPs for four services. I've attached my configuration and a
bigger chunk of the logs. The new VIP address services I'm trying to
add is 10.0.0.121.
Any help figuring this out would be greatly appreciated. I'm running
keepalived version 1.1.11.
Thanks,
Tom
|
