|
Try something like this :
# ifconfig eth0:41 down
On Mon, Feb 22, 2010 at 4:56 PM, Luis Torres <al1629608@xxxxxxxxx> wrote:
> Hi, this is probably a newbie question but I've searched everywhere for the
> answer with no luck.
>
> I inherited an LVS setup with an lvs.cf like the following (IPs
> intentionally changed):
> virtual vip_r_30 {
> active = 1
> address = 66.66.66.66 eth0:40
> vip_nmask = 255.255.255.0
> load_monitor = none
> quiesce_server = 0
> }
> virtual vip_r_31 {
> active = 1
> address = 66.66.66.67 eth0:41
> vip_nmask = 255.255.255.0
> load_monitor = none
> quiesce_server = 0
> }
>
> That's just a small section of the config file.
>
> Anyone know how I can control each one of those entries independently? I
> want to bring down vip_r_31 which shows as eth0:41 when doing ifconfig but I
> read I cant use that command or ifup/ifdown.
>
> What command can I then use to bring down just eth0:41? (ifdown if it were
> just another alias)
>
> What about making it active again? (ifup if it were just another alias).
>
> The setup I inherited is command line only so I can't use any GUI to
> accomplish this.
>
> Any help is greatly appreciated.
>
> A.
>
>
>
> _______________________________________________
> Please read the documentation before posting - it's available at:
> http://www.linuxvirtualserver.org/
>
> LinuxVirtualServer.org mailing list - lvs-users@xxxxxxxxxxxxxxxxxxxxxx
> Send requests to lvs-users-request@xxxxxxxxxxxxxxxxxxxxxx
> or go to http://lists.graemef.net/mailman/listinfo/lvs-users
>
_______________________________________________
Please read the documentation before posting - it's available at:
http://www.linuxvirtualserver.org/
LinuxVirtualServer.org mailing list - lvs-users@xxxxxxxxxxxxxxxxxxxxxx
Send requests to lvs-users-request@xxxxxxxxxxxxxxxxxxxxxx
or go to http://lists.graemef.net/mailman/listinfo/lvs-users
|
