|
Hi,
We're trying to get IPVS working on Centos7 and running into something I
didn't see on earlier versions. IPVS is working otherwise. It is able to
load balance to backends and such but I cannot make the master/backup
daemons start.
I don't really have a lot to go on really and looking for suggested avenues
of investigation. I did try deleting the ipv6 address off this vlan
interface but it didn't help. (I read syncing only works with ipv4).
# ipvsadm --start-daemon master --mcast-interface vlan1101 --syncid 1
No such device or address
# ip addr show dev vlan1101
9: vlan1101@bond0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 9000 qdisc noqueue
state UP qlen 1000
link/ether 00:0a:f7:bd:c7:04 brd ff:ff:ff:ff:ff:ff
inet 10.241.8.69/26 brd 10.241.8.127 scope global vlan1101
valid_lft forever preferred_lft forever
inet6 fe80::20a:f7ff:febd:c704/64 scope link
valid_lft forever preferred_lft forever
# cat /etc/redhat-release
CentOS Linux release 7.4.1708 (Core)
# uname --r
3.10.0-862.3.2.el7.x86_64
ipvsadm v1.27 2008/5/15 (compiled with popt and IPVS v1.2.1)
_______________________________________________
Please read the documentation before posting - it's available at:
http://www.linuxvirtualserver.org/
LinuxVirtualServer.org mailing list - lvs-users@xxxxxxxxxxxxxxxxxxxxxx
Send requests to lvs-users-request@xxxxxxxxxxxxxxxxxxxxxx
or go to http://lists.graemef.net/mailman/listinfo/lvs-users
|
