|
I'm playing with LVS to try and get a working test setup going, and
I'm running into some problems. I've got three VMs -- two "real"
servers, one LVS router. Everything appears to start up correctly,
'ipvsadm -L' looks like I think it should, but the routing from the
VIP to the real servers just plain isn't happening. Network
connectivity between the router and real servers works fine, but I
can't even connect to the VIP on port 80.
Following Redhat's documentation, I've tried both the iptables
PREROUTING and the arptables methods, but neither has worked.
I'm sure I've made a silly mistake, but I can't for the life of me
figure it out. And LVS's logging is so quiet that I'm not getting
much; all appears to be working according to the logs.
Thanks for your help!
##### lvs.cf #####
service = lvs
primary = 10.9.3.3
heartbeat = 1
heartbeat_port = 1050
keepalive = 6
deadtime = 18
reservation_conflict_action = preempt
debug_level = NONE
network = direct
virtual server1 {
address = 10.9.3.6 eth0:1
vip_nmask = 255.255.0.0
fwmark = 100
active = 1
load_monitor = rup
timeout = 5
reentry = 10
port = http
send = "GET / HTTP/1.0\r\n\r\n"
expect = "HTTP"
protocol = tcp
server Real1 {
address = 10.9.3.1
active = 1
weight = 1
}
server Real2 {
address = 10.9.3.2
active = 1
weight = 1
}
}
Chris St. Pierre
Unix Systems Administrator
Nebraska Wesleyan University
_______________________________________________
Please read the documentation before posting - it's available at:
http://www.linuxvirtualserver.org/
LinuxVirtualServer.org mailing list - lvs-users@xxxxxxxxxxxxxxxxxxxxxx
Send requests to lvs-users-request@xxxxxxxxxxxxxxxxxxxxxx
or go to http://lists.graemef.net/mailman/listinfo/lvs-users
|
