|
Ferenc Wagner <wferi@xxxxxxx> writes:
> If I add an IPv4 network to the loopback device, that answers all
> addresses in the network, which is convenient on the fwmark-based
> director (with a corresponding static network route configured on the
> upstream router). These altogether make VIP-less director possible.
>
> But if I try to do the same with IPv6, no dice. If I add an IPv6
> network to the loopback device, that does NOT answer all the addresses
> in the network, and even if I add a local route for the network, that
> shows up as unreachable in the routing table listing.
>
> Is it possible to employ some trick to "localize" a network of IPv6
> addresses, so that IPVS catches and routes them?
Looks like the Any-IP support added to 2.6.37 solves this with utter
elegance: 'ip route add PREFIX dev lo' is enough in itself. At least
until the IPVS hook moves into FORWARD...
--
Regards,
Feri.
_______________________________________________
Please read the documentation before posting - it's available at:
http://www.linuxvirtualserver.org/
LinuxVirtualServer.org mailing list - lvs-users@xxxxxxxxxxxxxxxxxxxxxx
Send requests to lvs-users-request@xxxxxxxxxxxxxxxxxxxxxx
or go to http://lists.graemef.net/mailman/listinfo/lvs-users
|
