|
Xavier Mertens wrote:
>
> Hi,
>
> For a few services, I've the following config:
>
> UDP radius-vs:rad-acct rr
> -> radius2:rad-acct Route 65535 0 0
> -> radius1:rad-acct Route 1 0 1
>
> I would like to use "radius2" only as backup in case of "radius1" failure.
> I add/remove the nodes via a monitoring job.
>
> But, even if there is no problem on "radius1", sometimes, it switches to
can you only have radius1 in the ipvsadm table, and add radius2 when
radius1 fails?
instead of LVS, howabout using Linux HA with heartbeat between
radius1 and radius2?
Joe
--
Joseph Mack PhD, Senior Systems Engineer, Lockheed Martin
contractor to the National Environmental Supercomputer Center,
mailto:mack.joseph@xxxxxxx ph# 919-541-0007, RTP, NC, USA
|
