|
> When I try to run rc.lvs_nat (produced by configure script 0.9.4) on
> realserver,
> it show out can not set iptable and ipchain.
> My question is do I need set up any config on realserver (rh7.3 with 2.4.18-3
> kernel)
> before I try to run rc.lvs_nat?
Not sure. You can look to see if these are warnings (in which case you can
proceed)
or errors (in which case installation will fail).
Unfortunately I've not been very clear about setting warnings and errors and
sometimes
a message will be of the wrong class.
Either
o try it and see if it runs
o install iptables support
Joe
--
Joseph Mack PhD, Senior Systems Engineer, SAIC contractor
to the National Environmental Supercomputer Center,
mailto:mack.joseph@xxxxxxx ph# 919-541-0007, RTP, NC, USA
|
