LVS with 2 nics

["Bishop, Cass" <cbishop@xxxxxxxxxxxxxxxxx>]

I am trying to set a test LVS system and keep running into trouble.  I went through the Mini-HOWTO including the "What if there are problems" section.  My problems is one of the ones listed there: "connection hangs; ipvsadm shows entries in InActConn, but none in ActiveConn".

The Director and the realservers all have 2 nics.  One for the primary network (4) and the other for the backup network (8). 

DIP=172.27.7.14
VIP=172.27.7.239 (eth0:1)

Here is the output of route on the realservers:
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
172.27.8.0      *               255.255.255.0   U     0      0        0 eth1
172.27.4.0      *               255.255.252.0   U     0      0        0 eth0
127.0.0.0       *               255.0.0.0       U     0      0        0 lo
default         172.27.7.14     0.0.0.0         UG    0      0        0 eth0

After reading the "Problems" section of the mini-HOWTO I'm wondering if the entry for the backup network is causing my connections to hang and get entered in the InActConn column.  Any ideas?

Cass Bishop
Web/Voice Systems Engineer
ATX Technologies
972-753-6289

CONFIDENTIALITY NOTICE:  The information in this e-mail is privileged and confidential.  Any use, copying or dissemination of any portion of this e-mail by or to anyone other than the intended recipient(s) is unauthorized.  If you have received this e-mail in error, please reply to sender and delete it from your system immediately.