|
Rafael Morales wrote:
>
> When I put ip route show this appears
>
> 10.2.2.71 dev lo scope link src 10.2.2.71
> 10.2.2.0/24 dev eth0 scope link
> 169.254.0.0/16 dev eth0 scope link
> 127.0.0.0/8 dev lo scope link
> default via 10.2.2.254 dev eth0
>
> Where my gateway is 10.2.2.254 and my VIP is 10.2.2.71. However my servers can
> not connect to internet. You say me I use ip route del xxxx table xxx but
> what it means the xxxx ????
you don't have any special routing, so forget about what I said.
> > > [root@squid3 root]# ./rc.lvs.dr
> > > [root@squid3 root]# route add -net default gw MY_GATE
> > > [root@squid3 root]# telnet www.cisco.com 80
try with a website that's a little closer (eg at your work, but
on a different network to the VIP)
> > > Trying 198.133.219.25...
> > >
> > > However my servers can not connect to internet.
> > > I hope to be clear :) thanks and regards
hmm,
can the realservers connect to the target website before you run the rc.lvs_dr
script?
If yes, what is the difference in the routing tables etc.
Can you ping a target website before/after running the script?
Joe
--
Joseph Mack PhD, High Performance Computing & Scientific Visualization
SAIC, Supporting the EPA Research Triangle Park, NC 919-541-0007
Federal Contact - John B. Smith 919-541-1087 - smith.johnb@xxxxxxx
|
