|
On Wed, Dec 13, 2006 at 11:56:43AM -0800, Jed Reynolds wrote:
> I've read the MiniHowto and the UltraMonkey Tutorial. Something that I'm
> not entirely clear on if I can do a direct routing setup with only using
> one routable IP address (aka, the VIP).
>
> What I would like to do is to put the realservers on a DMZ with
> non-routable addresses. And since I have two nics on the realservers,
> can I configure the realserver nics plugged into the WAN switch with the
> VIP? (arp_ignore of course). And then I wouldn't need to do a lo:0,
> would I ?
>
> Like so:
>
> WAN: x.200.200.112/28
> VIP: x.200.200.113
> DIP: 10.0.0.2
> RIP eth0: 10.0.0.3
> RIP eth1: x.200.200.113
What you are suggesting should work, as long as the real servers
can receive incoming packets from the linux director, and send
replies back to the the end-users. Its not important
what IP addresses real servers have.
--
Horms
H: http://www.vergenet.net/~horms/
W: http://www.valinux.co.jp/en/
|
