|
Am Donnerstag, 31. Dezember 2009 01:50:24 schrieb martin hubert:
> I am trying to replace a old lvs setup that was running ultra monkey
>
>
>
> We have two LVS1 & LVS2
>
> Both with 3 NIC 1 public 2 private
>
>
>
> I have source based routing running on the real servers so that works well
> - but I can't figure out how to get piranha to accept 2 Virtual NAT IP
> addresses
>
>
>
> Public
>
> eth2 a.b.c.d
>
>
>
> [LVS1]
>
>
>
> NAT*
>
> Eth0:1 192.168.101.1
>
> Eth1:1 192.168.102.1
>
>
>
>
>
> In case of a fail over I would like both NAT IP addresses to float over to
> LVS2
>
> Eth0:1 192.168.101.1
>
> Eth1:1 192.168.102.1
>
>
>
> Any ideas?
>
>
>
> I could probably try to migrate to direct routing but like the fact that
> the real servers have NO physical connection to the Internet.
>
>
>
> The other compromise idea would be to have 192.168.102.1 statically sit on
> the LVS1 and no 102-subnet on LVS2 in case of a failover there would then
> be traffic on the 192.168.102 subnet
>
>
>
> Still not quite what I want so.
>
>
>
> Thx in advance and happy new year
>
>
>
> _______________________________________________
> Please read the documentation before posting - it's available at:
> http://www.linuxvirtualserver.org/
>
> LinuxVirtualServer.org mailing list - lvs-users@xxxxxxxxxxxxxxxxxxxxxx
> Send requests to lvs-users-request@xxxxxxxxxxxxxxxxxxxxxx
> or go to http://lists.graemef.net/mailman/listinfo/lvs-users
Perhaps you try using bonding interfaces. That would make the setup much
easier.
Michael Schwartzkopff
_______________________________________________
Please read the documentation before posting - it's available at:
http://www.linuxvirtualserver.org/
LinuxVirtualServer.org mailing list - lvs-users@xxxxxxxxxxxxxxxxxxxxxx
Send requests to lvs-users-request@xxxxxxxxxxxxxxxxxxxxxx
or go to http://lists.graemef.net/mailman/listinfo/lvs-users
|
