|
Laurent Lefoll wrote:
> If I dynamically change the timeout value, will this value be also applied to
> existing established connections or only new connections will see this new
> timeout ? (I have no hand on a LVS box right now to perform some tests....)
if you apply a value of 0, it only applies to new connections.
I assume if you apply any other weight, its value will only
apply to the new connections too
Joe
--
Joseph Mack PhD, Senior Systems Engineer, Lockheed Martin
contractor to the National Environmental Supercomputer Center,
mailto:mack.joseph@xxxxxxx ph# 919-541-0007, RTP, NC, USA
|
