|
Ahah, I just ran into this problem.
Notice this:
% cat /usr/include/linux/version.h
#define UTS_RELEASE "2.4.20"
The configure script first looks in /usr/src/linux for version.h then
it looks in /usr/include. Try running
rpmbuild -bp --target i686 kernel-2.6.spec
That should generate version.h. Then do a sym link:
ln -s /usr/src/redhat/BUILD/kernel-2.6.16/linux-2.6.16.i686 /usr/src/linux
Run configure again and it should see that you're using the 2.6 kernel.
On 12/7/06, Navid Rahimi <navid.rahimi@xxxxxxxxx> wrote:
Thanks for the reply...I do have all the modues. I found my problem....there
seems to be a problem in the spec file or how rpms are built, not sure who
to blame here. I originally ran ./configure and made sure every thing was
ok then built the rpms and installed it...after carefully reviewing the
rpmbuild output i noticed that it thinks i have kernel 2.4.20 while i have
2.6.9. then it couldn't find some of the libraries and thus it didn't
include ipvs support. the moral of the story: don't build the rpm!
Navid
On 12/6/06, J.Libak@xxxxxxxxxx <J.Libak@xxxxxxxxxx> wrote:
>
> Navid Rahimi wrote:
> > Hi,
> >
> > I am running RHEL4 ( 2.6.9-42.0.3.ELsmp), ipvsadm v1.24, keepalived
> > v1.1.13.
> > I can get virtual ip addresses to fail-over but when I add a virtual
> > service
> > nothing gets added to LVS, ipvsadm -L shows nothing. I compiled both
> > ipvsadm
> > and keepalived from source. During the compliation I did make sure IPVS
> > framework/sync daemon support were enabled. Yet no virtual services
> > show up
> > in ipvsadm. I am trying to setup a streamlined ha/load balancer i.e.
> > the LVS
> > router and real servers are the same.
> > VIP: 10.1.1.100
> > LVS routers/real servers :10.1.1.20, 10.1.1.30
> >
> > Any help or suggestions would be greatly appreciated.
> >
> > Thanks,
> > Navid
> Did you load the ip_vs module and other ip_vs_* modules? Does lsmod show
> them?
> Did you use ipvsadm -A ... to add a new service?
>
--
"We make a living by what we get, we make a life by what we give."
-Sir Winston Churchill (1874 - 1965)
_______________________________________________
LinuxVirtualServer.org mailing list - lvs-users@xxxxxxxxxxxxxxxxxxxxxx
Send requests to lvs-users-request@xxxxxxxxxxxxxxxxxxxxxx
or go to http://www.in-addr.de/mailman/listinfo/lvs-users
|
