|
On Thu, Aug 03, 2000 at 10:56:25AM -0700, Michael McConnell wrote:
> So what your saying is, they can actually go into a hub, they just can't be
> routed?
> I've attached a little diagram, can you tell me if this little picture would
> work for Direct Routing? (yahh visio)
>
> I had been under the impression that they either had to be connected via a
> Coax Cable, or a Cross over connection going from NIC to NIC.
What you have is fine, as you say they just need to be not routed. Having
Coax, Switched or non-Switched cat 5 or fibre is fine.
--
Horms
|
